Stop gambling with seasonal dry spells and wasteful flood irrigation. The 0.3mm Thick -16mm Drip Tape Irrigation Line delivers steady, root-level moisture that keeps crop foliage dry – dramatically reducing fungal leaf diseases like early and late blight while leaving inter-row paths dry to suppress weed growth.
Engineered with continuous internal turbulent flow labyrinths, each dripper resists clogging and maintains consistent discharge rates across long bed runs under low-to-medium operating pressure.
Key Features & Benefits
-
Heavy-Duty 0.3mm Wall: Thicker than standard thin-wall tapes, providing enhanced resistance against punctures, insect damage, UV degradation, and dragging during field installation.
-
Clog-Resistant Emitter Design: Features wide turbulent flow paths and built-in inlet filters that prevent silt and fine particles from settling in the discharge channels.
-
Uniform Water Discharge: Delivers a balanced flow rate (approx 1.0 – 1.5 Liters per Hour per dripper) to ensure even crop growth from the start of the row to the end.
-
Multi-Season Reusability: Easily roll out at planting and roll up after harvest for storage and reuse across multiple cropping cycles.
-
Fertigation Ready: Allows complete integration with Venturi injectors to deliver liquid fertilizers directly to the root zone for immediate plant absorption.
Emitter Spacing & Crop Selection Guide
Select the right emitter spacing based on your specific crop requirements:
Emitter Spacing Flow Rate per Dripper Recommended Crops & Layouts 15cm Spacing 1.0 L/h Close-density crops: Onions, garlic, carrots, herbs, and garlic. 20cm Spacing 1.0 – 1.2 L/h Medium-density crops: Cabbages, kale (sukuma wiki), spinach, and French beans. 30cm Spacing 1.2 – 1.5 L/h Standard vegetable spacing: Tomatoes, capsicum (sweet pepper), chili, and eggplants. Installation & Best Practices
-
Bed Preparation: Ensure beds are smooth and free of sharp stones or coarse roots that could puncture the tape.
-
Emitter Alignment: Unroll the drip tape along the bed with the dripper outlets facing UPWARD. This prevents soil silt from settling inside the emitters when water shuts off.
-
Flushing & Sealing: Before sealing the ends, flush water through the lines for 3 – 5 minutes to clear out soil or pipe shavings. Secure ends using 16 mm Figure-8 end closures.
-
Filtration Required: Always install a 1.5″ or 2″ Disc Filter (120 mesh / 130 micron) at your mainline source to prevent dripper blockages.
-







Reviews
There are no reviews yet.